Table of Contents
Advertisement
78
In this mode, you can adjust the settings for the Equalizer.
An Equalizer is used to adjust the tonal quality. Th e built-in Equalizer consists of 3
bands and Tone Control. With the 3 bands ranging bass to treble, you can boost or
cut any of them.
To locate this mode:
DRAWBARS
1. TONE CONTROL
Th is models the "screw-set" tone control that was present on the preamp inside of
the vintage Hammond B-3. It gently cuts the treble.
Th e setting range is -9 to +9, and it becomes neutral when set at "0".
"-1" corresponds to the maximum of the B-3/C-3 tone control, "-5", the middle,
"-9" the minimum. Th e tone control found on the B-3/C-3, it's value can not be set
at "+", but on this model it's possible to boost treble to some extent.
2. GAIN - BASS
3. GAIN - MIDDLE
5. GAIN - TREBLE
Th ese are for doing the Boost / Cut of Bass, Middle and Treble respectively. Th e set-
ting range is -9 to +9. It gets neutral at 0.
4. FREQUENCY - MIDDLE
Th is is for setting the Central Frequency to vary at Gain - Middle (#3).
Th e setting range is 480Hz - 2.9Hz.
EXTRA VOICE
6. GAIN - BASS
7. GAIN - MIDDLE
8. GAIN - TREBLE
Th ese are for doing the Boost / Cut of Bass, Middle and Treble respectively. Th e set-
ting range is -9 to +9. It gets neutral at 0.
9. FREQUENCY - MIDDLE
Th is is for setting the Central Frequency to vary at Gain - Middle (#7).
Th e setting range is 480Hz - 2.9Hz.
EQUALIZ (EQUALIZer)
Touch the [MENU] button for the MENU, select page C by the [PAGE] button, and
then touch the [2] EQUALIZ button.
1
Owner's Manual
6
7
8
9
2
3
4
5
+3dB
-3dB
-9dB
-15dB
+9dB
-9dB
THE EFFECTIVE USE OF THE MIDDLE FREQUENCY
Gain
0dB
100Hz
1kHz
10kHz
Gain
Bass
Middle
Gain
Gain
0dB
1kHz
Middle Freq.
The frequency response of the horn rotor in the
Leslie speaker is not fl at. It has a peak from 1kHz
to 3kHz that it is another component of the classic
HAMMOND sound.
When you use this organ on line out without a Le-
slie speaker, you can get the similar eff ect by set-
ting the FREQUENCY - MIDDLE to about 2kHz, and
the GAIN - MIDDLE to "+".
PRESET PARAMETERS
Equalizer is a Preset Parameter, designed to ac-
tively use as one of the tone-making parameters.
However, it is not practical to use Equalizer as a
tonal complementary tool to match the location.
In such a case, if you switch OFF the P. LOAD RV/EQ
in the PRESET function mode, the Equalizer value
does not change when the preset is recalled. (P. 60)
TC
+9
0
-1
-5
-9
Frequency
Treble
Gain
Frequency
Advertisement
Table of Contents
