Table of Contents
Advertisement
22
How to power on
SWELL
PEDAL
GREAT
PRESET
TRANSPOSE
1
2
3
PAGE/
PARAM.
VALUE
SONG
MENU
JUMP
SEQUENCER
Switch-off memory
Reset to the initial status
POWER ON
After connecting your A-405SP to the power outlet, please perform the following procedure
before switching on the power. To avoid possible damages to speakers, please do not vary the
procedure.
STEPS TO TAKE
1. Set the [MASTER VOLUME] knob at 0 (minimum), before switching the power on.
2. Switch on the [POWER] on the top panel. "PLAY" mode appears, following the TITLE,
in the Display window.
The circuit protection devices create a few second delay before the A-405SP is ready
to play.
3. Switch on the power of the external amplifi ers etc. connected to the A-405SP.
4. Holding down a key, adjust the [MASTER VOLUME] by turning the knob.
The Preset button [CANCEL] does not produce sound when initially fi rst turned on.
Draw the Drawbars, or press either of the Preset Buttons [1] - [9] to start.
5. Adjust the volume of the amplifi ers etc.
Reverse the above steps when you switch off the power . (Switch off the power of the
amplifi ers etc. fi rst.)
4
PLAY
Your A-405SP memorizes the setting of the organ immediately before it is switched off . So,
the organ will start with these settings when it is switched on again.
Th e A-405SP is initially shipped from the factory with the Preset Button [CANCEL] in
"pressed" status.
Please perform the following steps to reset the A-405SP to the initial default setting.
STEPS TO TAKE
1.
Switch off the power of the A-405SP.
2.
Holding the [RECORD] button, switch on the power.
3.
Hold down / keep pressing the [RECORD] button until "Loading Default..." appears
on the Display.
4.
If everything is in order, "PLAY" mode appears on the Display. (Completed)
Owner's Manual
Advertisement
Table of Contents
