Additional Component Removal - Manitowoc S Installation, Use & Care Manual

Maintenance

Additional Component Removal

The following components may be removed for easier
access in some installations or they may need to be
removed and cleaned to correct an operational problem.
Door Removal
1. Use a phillips screwdriver to loosen the two screws
securing the left and right doors. Do not remove they
are secured to prevent loss.
2. 30 Inch and 48 Inch Models: To remove right front
door lift up and remove (22 inch ice machines have
a single door, lift to remove entire door).
4
Door Removal
3. Open left front door to 45 degrees.
4. Support with right hand, depress top pin, tilt top of
door forward and lift out of bottom pin to remove.
4-14
Water Inlet Valve
The water inlet valve normally does not require removal
for cleaning. Refer to Section 5 for a list of causes for
"No Water Entering Water Trough" or "Water Overflows
Water Trough.
1. When the ice machine is off, the water inlet valve
must completely stop water flow into the machine.
2. When the ice machine is on, the water inlet valve
must allow the proper water flow through it. Set the
toggle switch to ON. Watch for water flow into the ice
machine. If the water flow is slow or only trickles into
the ice machine, refer to Section 5.
Follow the procedure below to remove the water inlet
valve.
Disconnect the electric power to the ice machine
and dispenser at the electric service switch box and
turn off the water supply before proceeding.
2
1. Remove the 1/4" hex head screws.
2. Remove, clean, and install the filter screen.
FILTER
ACCESS
SCREWS
1
! Warning
FILTER
SCREEN
LOCATION
Part Number 000000966 03/09
Section 4
WATER
INLET
VALVE