Error Display - Canon PIXMA MP150 Service Manual

3. ERROR DISPLAY

The errors / alarms occurred in the printer is displayed as follows:
1) In Operator Call Error, the Alarm LED is lit to display an error.
(In a service mode, an error is displayed by the Alarm LED blinking.)
Service Call Error is displayed by the number of the Alarm LED blinking.
2) An error / alarm is displayed on the LCD monitor of the operation panel.
3) An alarm is displayed on the status monitor of the printer driver.
3-1. Operator Call Error (Alarm LED Blinking in Orange)
LED display
E2 2 times
E3 3 times
E4
E5 5 times
E8
E9
E14
E15 15 times
E16
Alarm LED blinking
(Service mode)
No paper
(ASF)[1000]
Paper jam[1300]
- No ink[1600]
The ink cartridges are
not installed[1401],
or a non-supported ink
cartridge is
installed[1485],
or the ink cartridges are
not installed
properly[1687].
- Waste ink absorber
full[1700],
or platen waste ink
absorber full[1710].
- The connected digital
camera / video camera
does not support
Camera Direct
Printing.[2001]
- The Ink cartridges whose
destination are
wrong.[1684]
Ink cartridge is not
installed.[1682]
- Ink remaining is
unknown. [1685/1686]
Error
Corrective action
(Error code)
Set paper in ASF, and
press the OK button.
Remove the jammed
paper, and press the OK
button.
Replace the ink
cartridge(s), or press the
OK button.
Check if supported ink
tank(s) is installed, and
re-install them properly,
and then close the
scanning unit.
Pressing the OK button
will clean the error, and
enable to print.
In repair,
<Replacement of Ink
absorber kit
(QY5-0149-000)>
<Replacement of Platen
waste ink absorber
QC1-6014-000)>
Disconnect the cable
from a the digital
camera/video camera,
and press the Reset
button, and then
re-connect the cable.
Check if supported ink
tank(s) is installed, and
re-install it properly, and
then close the scanning
unit.
Re-install the ink
cartridge(s) properly and
close the scanning unit.
Or Turn on/off the
machine with the ink
cartridges installed.
Install an new ink
cartridge, or press the
OK button.
* When an cartridge that
was once used
(excluding the cartridge
used just before) is
installed, this error
occurs.
(7/24)
Remarks
When selecting to press
the OK button, ink may
run out during printing.
Waste ink absorber full
warning (service call
error) may appear.
When the error is
resolved by pressing the
OK button, the function
for detecting the
remaining ink level will
be released.