Transom Ski Tow Ring; Maintenance; Windshield - Scarab jet boat Owenrs Manual

C. Transom Ski Tow
The stainless steel transom ski tow is mounted on
the transom above the swim platform. Scarab recom-
mends no more than two skiers be pulled behind the
boat at any time. See Figure C4.
NOTICE
Refer to A-13 Water Sports of the Boating Safe-
ty & Information section of this manual often.
Figure C4: Transom Ski Tow
always have an observer,proceed with only as
much speed as required, and follow the observ-
er's instructions.
the boat handle differently and requires greater
Be advised that serious injury can result if the
when circling. The rope could become wrapped
for lifting or parasailing. Fittings could pull out of
Boat Equipment - Section C
To prevent personal injury or damage to the
NOTICE
gear, and operator's experi ence will affect the
D. Maintenance
The majority of the hardware installed is made of
stainless steel. Regardless of the type of hard ware
used, periodic mainte nance is necessary.
The manufacturer of the hardware recommends the
1. Rinse the hardware with fresh water after each
exposure to saltwater.
2. Periodically wash the hardware with mild soap,
warm water, and a sponge. Then dry it with a soft
cloth.
3. Avoid cleaners, abrasives, waxes, and most of all,
do not use steel wool.
NOTICE
loosening, wear, and damage. Prob lems should
be corrected immediate ly!
C - 2

WINDSHIELD

The windshield on all Scarab models is standard
equipment. See Figure C5. The windshield consists of
tem pered safety glass and the wind shield frame may
consist of either a painted, powder coated or anodized
alumi num (depending on the model). For easy acces-
sibility to and from the bow, a walk-thru center wind-
shield is standard. Stainless steel supports or braces
are used in most of the windshield assemblies.
Owner's Manual Page 66