Swivel Jack; Brake Actuator & Coupling Assembly; Winch; Lights - Scarab jet boat Owenrs Manual

length and width. Re-carpet bunks with high quality
exterior grade carpet.
Toxic fumes will be released. Dispose of
C. Swivel Jack
Keep the swivel jack clean of dirt, tar, and mud.
Lubricate every six months. The swivel jack's inner
ram should be lubricated with SAE 30 weight oil. The
top cover may be re moved to lubricate the gears with
wheel bearing grease.
Replace all worn and damaged parts. ALWAYS use
the manufacturer's replacement parts. Re placement
parts may be ordered through your Scarab dealer.
For more information on mainte nance, refer to the
manufact urer's litera ture included in the owner's
packet.
D. Brake Actuator & Coupling Assembly
When storing or parking your trailer, keep the brake
actuator and coupling assembly (coupler) off the
ground to prevent dirt buildup in the ball socket. Keep
the coupler clean of dirt, tar, and mud. Lubricate the
coupler with SAE 30 weight oil every six months or as
often as neces sary. Replace any worn or defective
parts. If the cou pler is dam aged, contact your Scarab
dealer for replace ment parts. DO NOT use a dam-
aged or bent coupler assembly.
For more information on maintenance, refer to the
manufact urer's litera ture included in the owner's
packet.
NOTICE
The trailer should be set up at a slight angle
to allow for water to drain aft in the boat.
E. Winch
The winch should be kept clean of dirt, ice, paint, etc.,
them at all times. Apply several drops of SAE 30
Trailer Information - Section F
weight oil to the ratchet pawl mecha nism, bushings
and pinion shaft threads twice per season.
Replace any worn or damaged parts. For more infor-
mation on mainte nance, refer to the manu fact urer's
litera ture included in the owner's packet.
F. Lights
Inspect wiring for cuts or bare wire which could cause
electrical shorts. Repair or replace defec tive wiring.
Replace cracked or damaged lens and always carry
spare bulbs. Re placement parts may be ordered
through a Scarab dealer.
G. Tie-downs
Replace frayed or damaged tie-downs. Periodi cally,
silicone spray. Replacement parts may be ordered
through a Scarab dealer.
H. Wheels
of the rims. Chrome wheel rims may be cleaned with
dish was hing soap and water. Also, there are clean-
Cleaners may be obtained from Scarab dealers and
your local auto parts stores. The aluminum wheel
manufacturer recom mends a product by Priority One®
nt™. Galva nized rims should be rinsed only with
clean water immediately after each use.
NOTICE
ALWAYS read the manufac tur er's in struc tions
on the label before using any prod uct.
I.

Brakes

Keep the actuator clean of dirt, tar, and mud. The
actuator and internal parts should be lubri cated at all
times with SAE 30 weight oil. The hitch ball may be
lubricated with automotive grease or lubricant made
for hitch balls.
Periodically inspect the brake system for leaks. Check
all hoses for cuts or wear. Replace all defective hoses.
from the top of the reservoir.
Owner's Manual Page 123