Boat Equipment; Deck Hardware; Grab Handles; Cleats - Scarab jet boat Owenrs Manual

NOTICE
Models may vary with regard to content based
on standard and options availability.
C - 1

DECK HARDWARE

models. Ensure that all equipment and hardware
only.
A. Grab Handles
Grab handles have been installed to provide security
for passengers in the cockpit. See Figure C1. All those
on board should be safely seated while underway.
Refer to person capacity label at the helm. Limiting
passen ger move ment while underway is recom mend-
ed. Additional care must be taken when in rough seas
or foul weather.
Figure C1: Passenger Grab Handle - Stern
Prevent personal injury or possible man-over-
board situations. Do not conduct maneuvers that
could launch passengers or driver from their seats
and/or overboard.
B. Cleats
designed and are intended to be used as mooring
cleats. Their purpose is for securing the vessel to
a dock, pier, mooring, or anchor. Use of fenders is
Boat Equipment - Section C
highly recommended when mooring to a dock. Also
be sure to tie off at both the bow and at the stern. Be
certain that a clear lead exists when running dock
lines or an anchor line. A line inadvertently threaded
around a stanchion or around a grab handle could
cause damage.
A pull-up style cleat is available for the Scarab mod-
-
els. If equipped, the pull-up cleat gives the boat a
sleek style. When you desire to use the cleat, simply
in and the cleat will remain in its retracted position until
the next time you desire to use it. See Figures C2 and
C3.
Figure C2: Pull-Up Cleat - Extended
Figure C3: Pull-Up Cleat - Retracted
Scarab boats are not equipped with any hardware
designed for towing other craft. The mooring
cleats that are in stalled on the boat are not to
be used for towing another vessel or having the
boat towed. Refer to the section on Sec tion A-17
Grounding & Towing for addition al precau tions.

Boat Equipment

Owner's Manual Page 65