Four Position Ignition Switch; Instrument Maintenance - Scarab jet boat Owenrs Manual

this system generates numbered fault codes
(P-XXXX) that are displayed through the information
center. In case of a failure, you may call your
authorized Scarab dealer and he would be able to
assist you to obtain the code descriptions to help
troubleshooting.
(SENSOR) - Sensor failure (boat electronic equip-
ment). See an authorized Scarab dealer.
Additional Information - A beeper will sound and
indicator light will blinks depending on the fault
occurring to catch the driver attention when ne-
an authorized Sarab dealer is contacted when other
messages occur.
above for additional information regarding messages.
F. Four Position Ignition Switch
START position is spring loaded and the key should
be held in this position until the engine starts but for
no more than 5 seconds at a time. If engine fails to
start after 5 seconds release the key. Wait 15 seconds
and then try again. Once engine starts, the key will
return to the RUN position once released.
Boat Systems - Section B
DO NOT hold in START position for more
START position longer then 5 seconds will
unable to start the motor. Damage to the
starter motors is also possible.
While engine is running, never turn the
to the starter may occur.
Always turn the key to the OFF position when the
engine is not running. This will prevent discharging of
the battery(s). The ACCESSORIES position allows
the operator to run the stereo without activating the
other ship's systems.
Should the boat be left unattended, be sure to
remove the key from the ignition to avoid possible
unauthorized use or theft.
G. Instrument Maintenance
Electrical protection for instruments and ignition
circuitry is provided by circuit breakers. The circuit
breakers are located on the battery switch panel. The
battery switch panel is typically located inside the port
stern seat storage compartment. Remove the port
stern seat cushion to access the battery switch panel.
Periodically, spray the ignition switch with a contact
cleaner. The ignition switch and all instruments,
controls, etc. should be protected from the weather
when not in use. Scarab offers appropriate weather
covers for each model. Excessive exposure can lead
DO NOT use a product such as WD-40 as a
contact cleaner. Be sure to read the label
before using any product.
Electronic gauges are affected by static electricity that
builds-up on the glass face. Periodic washing on the
gauge face with a dampened soft cloth and mild dish
detergent will help eliminate the static electricity
saturate gauges with water.
Owner's Manual Page 50