Installation Of Additional 12-Volt Equipment - Scarab jet boat Owenrs Manual

NOTICE
Always turn pump OFF after water is evacuated
or before operating the engine above idle.
Bilge pump will then switch to automatic mode.
The aft bilge pump is equipped with an automatic bilge
switch and will operate whenever bilge water rises to a
automatic bilge pump is active even if the battery
bilge pump circuitry is connected direct ly to the
battery. When leaving your boat unattended for an
ex tend ed period, check the charge on the battery
periodically. Also check the water level in the bilge
NOTICE
If boat is exposed to prolonged rain without a
cover, battery will discharge and bilge pump will
If the auto matic bilge pump must be dis abled, dis con-
nect the wiring plug near the bilge pump.
Blower - The BLOWER switch (Figure B19) is used to
activate the bilge blower. Toggle the switch to the
changing the air in the engine compartment that may
contain gas vapors.
Gasoline vapors can explode resulting in injury
compartment bilge for gasoline or vapors.
Operate blower for four minutes, and verify blower
operation. ALWAYS run the blower when the
vessel is operating below cruising speed.
Courtesy (Cockpit) Lights - The CTSY LTS switch is
used to activate the courtesy lights.
Horn - To sound the horn, press the HORN switch.
the bow lights, the all-around light and the instru ment
See Figure B18.
Boat Systems - Section B
Figure B18: Navigation & Anchor Light Switch
Digital Speed Control Switches - are located on the
dash. See Figure B19. These switches include the
MODE, SET and UP & DOWN (Toggle) switches.
These switches allow you to choose a type mode you
desire. These modes are CRUISE, SKI, ECO &
DOCKING. A detailed explanations along with the
instructions of how to program these various modes
are found in the Operation section of the this manual.
UP/DOWN (Toggle) Switch
Figure B19: Digital Speed Control Switches
2. Installation of Additional 12-Volt Equip ment
Non-factory in stalled 12-Volt accessory equipment
the dash.
protection for all 12-volt equip ment that is
installed. DO NOT overload the accessory
circuitry by installing too much additional 12-volt
equipment.
Nav/Anchor Light
SET Switch
MODE Switch
Owner's Manual Page 54