About Monitors When You Have A Codec C60 - Cisco Codec C60 Administrator's Manual

Cisco TelePresence System Codec C60/C40 and Profiles using C60/C40
Contents Introduction
About monitors when you have a
Codec C60
The main monitor
The monitor can be connected to any of the video outputs
HDMI 1 (the default connector for the main monitor) or DVI-I 2.
Connecting to HDMI 1
The HDMI 1 output is, by default, defined as the main monitor
connector. When you connect the main monitor to this output
the menu and icons (OSD - on screen display) will show on this
monitor.
Connecting to DVI-I 2
When connecting the main monitor to the DVI–I 2 output, you
must move the OSD to this output.
If you cannot see any menu on screen you must run a key
sequence on the remote control. The menu on screen, icons
and other information (OSD - on screen display) will be moved
to the selected output. At the same time, the resolution will be
set to the default value, which is 1024x768@60Hz for DVI (and
1280x720@60Hz for HDMI).
Moving the OSD using the remote control
If the main monitor is connected to DVI-I 2 video output, and the
OSD is on HDMI 1 output, you must run the following shortcut or
key sequence on the remote control.
• Disconnect * # * # 0 x # x=1 (HDMI 1) x=2 (DVI–I 2)
Example: Set DVI-I 2 as the OSD output:
– * – # – * – # – 0 – 2 – #
D14636.06 Profile C60-C40 and Codec C60-C40 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings
The video outputs at Codec C60
DVI-I 2
HDMI 1
(the default connector for
the main monitor)
Moving the OSD using the web interface
Go to the Advanced Configuration page and navigate to
Video > OSD > Output and select the video output connector for
the main mointor.
Moving the OSD using API commands
You can also set the resolution and the OSD output by setting
up a serial port connection and run API commands. See the API
Guide for the codec for information about API commands.
80
Password protection Appendices Appendices
Dual monitors
When you want to run a dual monitor setup, connect the second
monitor to video output DVI-I 2 video output on codec.
Dual monitor configuration
Go to Advanced configuration (menu on screen or web
interface) to set the monitor to dual:
1. Navigate to Video > Output > Monitor
Dual.
Administrator guide
Contact us
and set the Monitor to
www.cisco.com