To Receive A Data Or Fax Call; Manual Selection Of Incoming Data/Fax Calls - Nokia Phase A 6180i User Manual

Note: Data or fax calls cannot be initiated using your phone's
keypad. All data and fax calls must be initiated using the
data or fax software.
Note: Any touch tones (DTMF tones) needed for calling cards,
special long-distance access numbers, etc. must be
programmed into the dialing string.

To receive a data or fax call

Your phone must be connected to your PC via the data
cable.
The appropriate data or fax software must be run-
1.
ning. Consider setting your data or fax software to
automatically answer incoming calls so you can
receive them while away from your PC.
When you receive a call, Data call or Fax call
2.
appears and an alert sounds.
Terminate the data call from your data software; fax
3.
calls typically terminate automatically.
Note: Avoid terminating a call by pressing your phone's
key. This may cause your data or fax application to
temporarily lock up and could cause loss of data.

Manual selection of incoming data/fax calls

Certain service providers require that you preset your
phone to receive the incoming data or fax call, rather
than having the phone automatically detect the call type.
Note: Check with your service provider to see if "pre-
arrangement" of data and/or fax calls is necessary.
Most popular data and fax programs allow you to send
additional initialization commands to the modem when
the program is launched, or when the modem is
instructed to receive a call. You will need to modify your
phone's modem configuration in the data or fax software
so that it sends the following special initialization string
to the modem:
102
6180i Phase A
11/6/00 2:00pm