Table of Contents
Advertisement
Level III Service Manual
Removing and Replacing the Transceiver Board Assembly
G
6881038B70
1.
Remove the battery cover, battery, and front cover as described in the proce-
.
dures
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
2.
Using the Torx driver and T-6 bit, remove the 6 screws shown in Figure 9. Set
the screws aside for reuse.
TRANSCEIVER
BOARD ASSEMBLY
DISASSEMBLY TOOL
Figure 9. Removing the transceiver board assembly
3.
Using the flat end of the disassembly tool, carefully pry the transceiver board
assembly from the rear housing. The board assembly should separate easily
from the rear housing.
4.
Lift the transceiver board assembly completely away from the rear housing.
5.
To replace, align the transceiver board assembly with the rear housing and
press into place.
T-6 SCREW, 6 PLACES
July 27, 2001
Disassembly
REAR HOUSING
010510o
21
Advertisement
Table of Contents
Troubleshooting
