Removing And Replacing The Vibrator - Motorola T193 Service Manual

Level III Service Manual

Removing and Replacing the Vibrator

6881038B70
1. Remove the battery cover, battery, front cover, and transceiver board assembly
as described in the procedures
2. Using the flat end of the disassembly tool, carefully pry the vibrator from its
cavity in the rear housing. The vibrator should come away easily from the rear
housing. See Figure 15.
DISASSEMBLY TOOL
Figure 15. Removing the vibrator
3. To replace, insert the vibrator into the rear housing. Ensure the vibrator
terminals are properly aligned to contact the corresponding pads on the
transceiver board.
4. Replace the transceiver board assembly, front cover, battery, and battery cover
as described in the procedures.
July 27, 2001
.
Disassembly
VIBRATOR
REAR HOUSING
010517o
27