Removing And Replacing The Cover Plate - Motorola T193 Service Manual

Disassembly

Removing and Replacing the Cover Plate

G
G
22
6. After ensuring the transceiver board assembly is properly seated in the rear
housing, insert and tighten the 6 screws. Do not overtighten.
7. Replace the front cover, battery, and battery cover as described in the proce-
dures.
1. Remove the battery cover, battery, front cover, and transceiver board assembly
as described in the procedures
This product contains static-sensitive devices. Use anti-static handling procedures
to prevent electrostatic discharge (ESD) and component damage.
2. Using the flat end of the disassembly tool, carefully disengage the 2 cover plate
catches from the transceiver board.
The cover plate is reusable. Do not bend the catches permanently.
COVER PLATE
COVER PLATE
CATCH, 2 PLACES
Figure 10. Removing the cover plate
3. Carefully lift the cover plate from the transceiver board assembly as shown in
Figure 10.
4. To replace, align the cover plate with the transceiver board assembly and press
together until the catches snap into place. Ensure the cover plate is properly
aligned and flat against the transceiver board assembly.
5. Replace the transceiver board assembly, front cover, battery, and battery cover
as described in the procedures.
.
BOARD ASSEMBLY
July 27, 2001
Product Family C21
DISASSEMBLY TOOL
TRANSCEIVER
010512o
6881038B70