Motorola T193 Service Manual page 28

Disassembly
24
3. Using the flat end of the disassembly tool, gently pry the tabs away from the
transceiver board to release the display module.
LOCKING TAB
FLEX
TRANSCEIVER
BOARD
DISPLAY
MODULE
Figure 12. Removing the display module assembly
4. While holding the display module slightly away from the transceiver board,
use the pointed end of the disassembly tool to disengage the 2 flex connector
locking tabs as shown in Figure 12.
5. Pull the flex straight out of the connector, then lift the display module
completely away from the transceiver board.
6. To replace, insert the end of the display module flex into the connector on the
transceiver board. After ensuring the flex is straight and fully seated in the
connector, use the disassembly tool to push the locking tabs until completely
engaged.
7. Line up the display module mounting tabs with the corresponding notches in
the transceiver board, then press together until the display module snaps into
place.
8. Replace the cover plate, transceiver board assembly, front cover, battery, and
battery cover as described in the procedures.
FLEX
CONNECTOR
July 27, 2001
Product Family C21
DISASSEMBLY TOOL
010514o
6881038B70