Attaching Optional Belt Loop System - Extech Instruments S4000T User Manual

1.4 Attaching Optional Belt Loop System

The belt loop system consists of two parts:
A knob located on the back part of the printer just above the battery door
A strap with click on connector
To attach the strap to the knob insert the knob located at the bottom of the printer into the slot
of the connector. Pull down until you hear a click. The printer is now secure. The loop is then
placed over your belt. Allow the printer to hang down to either the left or right hip.
To release the printer, press in on the two latches on the connector and pull the knob clear of
the slot.
Note: Do not force or pull the printer from the connector without pressing in on the two latches
S4000T User's Guide
FIGURE 4: KNOB CONNECTION AND QUIK CLIP
Rev 1.2
Knob
10