HOME
TURN SIGNALS
REMOVAL
NOTE
To ensure correct installation, make note of wire routing and
cable strap locations before removing turn signals.
Bulbs
Remove screw on back of housing to access turn signal
bulbs.
Front
1.
See
Figure 7-49.
Disconnect bullet connectors on turn
signal wires.
2.
See
Figure 7-50.
Remove fastener (3) and lockwasher
(2) from fairing support bracket (4).
3.
Pull bullet connectors and wiring through hole in fairing
support bracket (4) and fairing (5).
Rear
1.
Remove seat See
2.38 SEAT.
2.
Remove tail frame upper body work. See
FRAME TAIL ASSEMBLY AND BODY
3.
See
Figure 7-52.
Disconnect bullet connectors on turn
signal wires.
4.
See
Figure 7-51.
Remove fastener (6) and lockwasher
(5).
NOTE
In next step, reflector bracket (3) will be removed with turn
signal (1).
5.
Remove turn signal from tail section (7) and license plate
bracket (4).
b1100x7x
b1007x7x
2.36 SUB-
WORK.
1.
2.
3.
4.
5.
6.
BE
BK
Left Turn
[31A]
Signal
Right Turn
Signal
BK
BE
[31A]
Figure 7-49. Front Turn Signal Connections
3
2
1
6
Turn signal (2)
Lockwasher (2)
Fastener (2)
Fairing support bracket
Fairing
Bulb
Figure 7-50. Front Turn Signals
2005 Buell Firebolt: Electrical
7.14
V
1
1
2
2
BK
[31B]
BK
2
2
BN
1
1
[31B]
5
4
7-45