Table of Contents
Advertisement
•
Available port number: 1 - 65535
•
Default: 123
The following port numbers are unavailable since they are already in use.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 161, 162, 443, 995, 10669, 10670
[Time adjustment interval]
Select an interval (1 - 24 hours: in 1 hour intervals) of synchronization with the NTP server.
•
Default: 1h
10.2.2 Configure the UPnP settings
This microphone supports UPnP (Universal Plug and Play). By using the UPnP function, it becomes possible
to configure the following automatically.
–
Configuration of the port forwarding function of the router. (However, a router supporting UPnP is required.)
This configuration is useful when accessing the microphone via the Internet.
–
Automatic refreshment of the shortcut to the microphone that is created on the [Network] folder of the PC
even when the IP address of the microphone changes.
[Auto port forwarding]
Select "On" or "Off" to determine whether or not to use the port forwarding function of the router.
To use the port forwarding function, the router in use must support UPnP and the UPnP must be enabled.
•
Default: Off
Note
•
Due to port forwarding, the port number may sometimes be changed. When the number is changed,
it is necessary to change the port numbers registered in the PC and recorders, etc.
•
The UPnP function is available when the microphone is connected to the IPv4 network. IPv6 is not
supported.
•
To check if auto port forwarding is properly configured, click the [Status] tab on the "Maintenance" page,
and check that "Enable" is displayed for "Status" of "UPnP". (®page 59)
When "Enable" is not displayed, refer to "Cannot access the microphone via the Internet." in the
"14 Troubleshooting" section. (®page 70)
[Short-cut to the microphone]
Select whether or not to create the shortcut to the microphone on the [Network] folder of the PC. When creating
the shortcut, select "On".
To use the Short-cut to the microphone function, enable the UPnP function on the PC in advance.
•
Default: Off
Note
•
To display the shortcut to the microphone on the [Network] folder of the PC, it is necessary to add the
Windows component. Refer to the following to enable the UPnP function.
10 Configuring the network settings [Network]
Operating Instructions
37
Advertisement
Table of Contents
