Table of Contents
Advertisement
•
Static: The IP address is configured by entering manually on "IP address(IPv4)".
•
DHCP: The IP address is configured using the DHCP function.
•
Auto(AutoIP): The IP address is configured using the DHCP function. When the DHCP server is not found,
the IP address is automatically configured.
•
Auto(Advanced): Using the DHCP function, network address information is referred to, and an unused
IP address is configured to the microphone as a static IP address. The configured IP address is
automatically determined within the subnet mask range by the microphone. When the DHCP server is not
found, the IP address is set to 192.168.0.10.
•
Default: Auto(Advanced)
Note
•
When "Auto(AutoIP)" is selected and the IP address cannot be obtained from the DHCP server, an IP
address not used in the same network will be searched within 169.254.1.0 - 169.254.254.255.
[IP address(IPv4)]
When not using the DHCP function, enter the IP address of the microphone. Do not enter an IP address already
in use (for the PCs and the other network cameras).
•
Default: 192.168.0.10
Note
•
Multiple IP addresses are unavailable even when using the DHCP function. Refer to the network
administrator for further information about the settings of the DHCP server.
[Subnet mask]
When not using the DHCP function, enter the subnet mask of the microphone.
•
Default: 255.255.255.0
[Default gateway]
When not using the DHCP function, enter the default gateway of the microphone.
•
Default: 192.168.0.1
Note
•
Multiple IP addresses for the default gateway are unavailable even when using the DHCP function.
Refer to the network administrator for further information about the settings of the DHCP server.
[DNS]
Determine how to set the address of the DNS server by selecting "Auto" (obtain the address automatically) or
"Manual" (enter the address of the DNS server). When "Manual" is selected, it is necessary to configure the
settings for the DNS.
When using the DHCP function, it is possible to obtain the DNS address automatically by selecting "Auto".
Refer to the network administrator for further information about the settings.
•
Default: Auto
[Primary server address], [Secondary server address]
When "Manual" is selected for "DNS", enter the IP address of the DNS server.
Refer to the network administrator about the IP address of the DNS server.
IPv6 network
[Manual]
Select "On" or "Off" to determine whether or not to manually configure the IP address for IPv6 network (IPv6
address).
•
On: Enter an IPv6 address manually.
10 Configuring the network settings [Network]
Operating Instructions
33
Advertisement
Table of Contents
