Panasonic WV-SMR10 Operating Instructions Manual page 23

Network microphone
Hide thumbs Also See for WV-SMR10:
Table of Contents

Advertisement

Unicast port (MANUAL): Up to 3 users can access a single microphone concurrently. It is necessary to
select "Unicast port" manually to transmit audio from the microphone.
It is possible to fix the port number of the router used for audio transmission via the Internet by setting
"Unicast port (MANUAL)" (®page 32). Refer to the operating instructions of the router in use.
Multicast: Unlimited number of users can access a single microphone concurrently. Complete the entry
field of "Multicast address", "Multicast port" and "Multicast TTL/HOPLimit" when transmitting audio with
multicast. Refer to page 6 for further information about the maximum concurrent access number.
Default: Unicast port (AUTO)
[Unicast port]
*1
Enter the unicast port number (used to transmit audio from the microphone).
Available port number: 1024 - 50000 (Only even numbers are available.)
Default: 32024
[Multicast address]
Enter the multicast IP address. Audio will be transmitted to the designated IP address.
Available IPv4 address: 224.0.0.0 - 239.255.255.255
Available IPv6 address: Multicast address starting with "FF"
Default: 239.192.0.20
Note
Enter a multicast IP address after checking available multicast addresses.
[Multicast port]
*2
Enter the multicast port number.
Available port number: 1024 - 50000 (Only even numbers are available.)
Default: 37004
[Multicast TTL/HOPLimit]
Enter a value for "Multicast TTL/HOPLimit".
Available value: 1-254
Default: 16
IMPORTANT
When transmitting audio via a network, the transmitted audio sometimes may not be heard depending
on the settings of a proxy server or a firewall. In this case, refer to the network administrator.
When two or more network interface cards are installed on the PC in use, the network interface
card(s) not used for receiving audio should be invalidated when receiving audio using the multicast
port.
It is necessary to designate the unicast port number when "Unicast port (MANUAL)" is selected for "Transmission type".
*1
*2
It is necessary to designate the multicast IP address when "Multicast" is selected for "Transmission type".
*2
*2
6 Configure the settings relating to audio [Audio]
Operating Instructions
23

Advertisement

Table of Contents
loading

Table of Contents