Table of Contents
Advertisement
If a password has been set, you will be required to enter in the
old password. Otherwise, select a new password that is 4 to 10
characters in length and enter it into the two fields labeled "New
Password." After clicking "OK" you will be prompted as to
whether the new password was successfully set on the VIP unit.
If it was successful, the Password field on the 'Sites' tab will be
filled in with your new password. This will also cause the VIP to
restart its software. After 5 seconds, it will reload the current
project and play it from the beginning.
The "Project to Publish" section allows you to select a project file
to always publish to this site. This will save you a step at
publish time, but only if you always use the same file. If you do
not plan on always using the same file, leave "Ask at Publish
Time" selected. (If this is your first time using VIP Composer,
then you probably have not created a project yet, so skip this
step and come back later if you want to change this setting.)
Depending on the way each VIP unit is connected, there are
different ways to set up each site description, depending on how
you want to publish your files to the VIP unit.
The new VIP units (version 2.00 and above) can only
be published to via the TCP/IP options. The other
options are left in for publishing to older VIP units.
Click on the "Connection Method" tab and then select one of the
following four types:
"Floppy" Sites
38
The "Floppy" publish method is
for VIP units that are not
connected to your PC via serial
cable, modem, or Ethernet
networking.
At publish time, you will be
prompted to insert a floppy disk,
and the pages for your project
will be automatically copied to
that disk.
VIP User Manual
Advertisement
Table of Contents
