Table of Contents
Advertisement
To change this setting, use the up/down arrows on the
keypad to adjust the digital display to match the IP address
you want to assign to your VIP system. (This address is
provided by your network administrator.) When you are
finished, select the "Set" button. You will be returned to the
Setup Screen.
Set the Subnet Mask
From the Setup Screen, select "Network" and then select
"Subnet". The following display should appear:
Use the up/down arrows on the keypad control to adjust the
digital display. Select the Subnet value that matches the one
used on your network. (This value is provided by your
network administrator.)
It is important that the Subnet match the Subnet of your
network, or communication with the VIP unit may not work.
When you are finished, select the "Set" button. You will be
returned to the Setup Screen.
Set the Gateway
From the Setup Screen, select "Network" and then select
"Gateway". The following display should appear:
If you are installing the VIP unit behind a router, the router
address must be entered in the Gateway setting before the
VIP will talk across the router. If you are using DHCP, this
value will be filled in automatically.
VIP User Manual
27
Advertisement
Table of Contents
