Table of Contents
Advertisement
Uploading Projects with VIP Composer
All projects must now be uploaded via the network. When setting up a
new site in the VIP Composer, use the "TCP\IP" option. Within this
option, the default
Protocol). (Refer to "Network Setup" on page 26).
Using DHCP
In the VIP Composer there are two ways to set up a site using DHCP
(see "The Setup Menu" in the VIP Composer Configuration section
of the user manual):
1. Leaving the MAC Address 00:00:00:00:00:00 – This will tell
the Composer to find an available VIP unit (see page 40).
2. Typing in a MAC Address – The MAC Address for the VIP
unit can be found on the "Quick Reference" sheet that came
with the unit (see page 40).
Using Static IP
Uncheck the DHCP box. This will allow you to fill in the IP Address
manually. Follow the instruction is the user's manual to set up the
IP Address on the VIP unit.
Setting Up Multiple Units
It is recommended that you use the "Quick Reference" card that is
included with the unit when setting it up. That way, if you use
option 1 described above, you will know which unit the Composer
located.
** If you are installing VIP Composer 2.00 over an old installation, you will need to go into
the site setup for each of your previously added sites and uncheck the DHCP box.
Setting the Password in Composer
Now included in the VIP is password protection. A password can be set
on the VIP unit through the Composer software. When setting up a new
site in the Composer, the password is set on the "general" tab. Follow
the steps on in the user manual (see page 37) to set the password on your
VIP unit.
10
method uses DHCP (Dynamic Host Control
**
VIP User Manual
Advertisement
Table of Contents
