Regulatory Compliance - Recon MOD Live User Manual

Regulatory Compliance
FCC Compliance Class B Digital Device
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
Page 72 MOD Live User Manual | Version 1.1 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com
FCC Declaration of Conformity
MOD Live (FCC ID: ZW5007) and Recon-Ready
Remote (ZW5001) comply with FCC standard
CRF 47 Part 15 subpart B and subpart C – section
15.249. Operation is subject to the following two
conditions:
• This device may not cause harmful
interference, and
• This device must accept any interference
received, including interference that may cause
undesired operation.
Industry Canada Compliance
MOD Live and Recon-Ready Remote were certified
with IC numbers 9717A-007 and 9717A-001,
respectively.
These devices comply with Industry Canada licence-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept
any interference, including interference that may
cause undesired operation of the device.
Cet appareil est conforme avec les normes de
l'Industrie Canada-sans les standards RSS (s).
L'utilisation est soumise aux deux conditions
suivantes: (1) cet appareil ne peut pas provoquer
d'interférences et (2) cet appareil doit accepter
toute interférence, y compris les interférences qui
peuvent causer un mauvais fonctionnement de
l'appareil.