Recon MOD Live User Manual page 68

Remote
Page 68
PAIRING A REMOTE CONTROLLER
Follow these steps when you unpaired a remote controller
by mistake, performed a factory reset, bought or borrowed a
replacement MOD or MOD Live unit.
To pair the remote controller with MOD Live:
1. Look on the back of the remote controller for the serial
number printed on a white label. Note the ID number.
2. If MOD Live is turned on, turn off the power button, wait
for a few seconds, and then turn the power button back on.
Wait for the prompt to press the MOD Live power button. This
prompt may show one or more remote ID numbers.
3. Press the MOD Live power button to navigate to the
remote ID that corresponds to your remote controller. Each
press of the power button will take you down to the next ID
on the list.
4. Wait for the counter to reach 0, and then press any button
on the remote.
5. Wait for a blue light to flash on the remote.
6. Check that the remote is paired by looking at the status bar.
Wait for the remote connection indicator icon to turn blue.
MOD Live User Manual | Version 1.1 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com