Recon MOD Live User Manual page 6

Charge Up Mod Live
NOTE: Always use the Recon AC adapter and USB cable shipped with your unit.
Never use third-party cables or adapters.
Page 6
1. To fully charge MOD Live using an AC adapter:
2. Make sure MOD Live is turned off before you start.
3. Assemble the AC adapter by inserting the North American
or European plug.
4. Insert the large plug of the USB cable into the adapter port.
5. Pop open the cover of MOD Live's USB port. Tip: the port
cover shows a tiny image of a USB cable. Insert the smaller
plug into MOD Live's USB port. Check that the plug's 7L
lettering appears on the outside of the goggle.
6. Plug the adapter into a power outlet. When MOD Live
begins charging, a red light appears directly above the
USB port. If the battery was drained after the unit left the
factory, it can take up to 3 hours for the battery to become
fully charged.
7. After the red light disappears, disconnect the adapter.
Remove the USB cable from MOD Live.
8. Replace the plastic USB port cover to ensure the port is
protected from rain, snow and ice.
MOD Live User Manual | Version 1.1 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com