Recon MOD Live User Manual page 53

MOD Live FAQ
MOD LIVE DISPLAY
Why is my display solid red or green?
MOD LIVE has a loose or broken connection. It can happen after a bad crash or damage to the
MOD LIVE components.
Steps to take:
1. Hold down the Power/Select button, wait a few minutes, and then press this button again.
2. If this does not work, try recharging the battery or contact Recon Support.
Why can't I see the edge of the display?
Steps to take:
1. Tilt or rotate the head of the micro-optic display.
2. Tighten the strap of your goggles.
3. Check that the MOD LIVE is snapped into your goggles.
MOD LIVE DATA
IMPORTANT NOTE: MOD LIVE can lose data or lose its connection to the remote controller due
to electromagnetic interference. Sources of interference include transmission towers, two-way
radios, wireless devices, industrial devices operating on RF frequency as well as motion sensors,
remote controls, and microwave ovens. GPS technology works best in open spaces with access
to at least three satellites. As long as the line of sight is clear, you won't have any problems
getting a satellite signal. Using MOD LIVE inside buildings and gondolas or near solid obstructions
such as trees and rock faces can interrupt GPS coverage and cause incorrect data to appear.
Page 53 MOD Live User Manual | Version 1.1 | © 2012 Recon Instruments Inc | All rights reserved | www.reconinstruments.com