HP60 SPYDER™
ATTACH HOSES
Attach one end of a solution hose to a wand or other tool, the
other end to the Spyder's™ front quick disconnect. Attach one
end of a vacuum hose to the tool, the other end to the Spyder's™
Cuff-Lynx™ vacuum hose port.
Release tool trigger. Turn on heater. Wait 8 – 10 minutes for unit
to pre-heat. Once heated, re-key upholstery tool until hot water
begins flowing. Once hot water is flowing, release trigger and
pre-heat an additional 4 – 5 minutes.
HEATER
After the machine has been plugged into a 20 amp grounded
outlet, turn on pump. Key tool until upholstery tool releases a
steady flow.
VACUUM MOTOR
Turn on vacuum motor and begin cleaning. For best results
make two dry passes to every wet pass.
4
PUMP