TRC UNIVERSAL IRRIGATION REMOTE CONTROL Operation And Installation Manual page 27

Fault Indication
Receiver fails to
respond, but the
power light is on.
Receiver's "Valve
On" indicator lights
during initial test,
but no valve or wrong
valve comes on.
Rain Bird's RC series
controller advances
to the first station with
remote operation.
Receiver turns off when
one station is activated.
Short Range
Check if the Receiver number was inadvertently
changed. Reprogram the Transmitter codes to match
the Receiver codes. (Press "1", "REC #")
Check the Group Code and Receiver Code dipswitches
on the Receiver. Reprogram the Transmitter to match
the Receiver codes. (See page 13).
Use an ohmmeter to check that your connector's
wire assignment matches your controller's valve
assignment.
Install the RC Series Controller Isolation Relay
(Part #02002).
Check solenoid. Current drain is more than 3 amps
and is tripping the resetting fuse.
Ensure that the antennas are firmly attached to the
Receiver and Transmitter.
Ensure that the antenna is clear from obstructions. The
three feet immediately surrounding the antenna are the
most crucial and should be kept clear of obstructions,
power lines, or electrical conduits, electric motors etc.
Keep the antenna as high as possible on the controller
and avoid situations where the antenna can be
shadowed by buildings or large metal structures.
Ensure that the Receiver's antenna is as far away from
electric motors, V.F.D.'s and overhead powerlines as
this type of equipment causes interference.
800-275-8558 www.remotecontroltech.com
Correction
27