Installing The Cache Module; Cpu Installation - DFI G586IPC User Manual

Installing the Cache Module

Locate the 160-pin cache module slot on the system board (SSM1).
See page 12 for the location. Position the cache module above the slot.
Make sure pin 1 of the cache module is aligned with pin 1 of the slot.
Carefully slide the module into the slot. Press firmly on the top of it to
seat it properly.
Note:
With the cache module installed in the cache module slot, the compo-
nents on the solder side of the add-in card in PCI Slot 4 must not pro-
trude more than 5mm.

CPU Installation

The G586IPC allows for easy installation of CPUs. Make sure all jumpers
are set correctly before applying power or you may damage the CPU or
system board. Please see the jumper settings on the following pages. Use
the needle-nosed pliers to move the jumpers if necessary. The table below
shows the External Bus Clock of the CPUs supported by the G586IPC sys-
tem board and their corresponding PCI Clock and Bus Clock.
External Bus Clock
50MHz
55MHz
60MHz
66MHz
16
PCI CLK Bus CLK
25MHz 8.333MHz
27.5MHz 9.1666MHz
30MHz 7.5MHz
33MHz 8.25MHz