Audiovox FLO TV Installation Manual page 8

Vehicle Preparation
1. Read the manuals to become familiar with the electrical requirements and connections of the
FLO TV kit.
2. Prepare the vehicle by removing any interior trim necessary to gain access to the vehicle's
wiring as well as areas where the interconnecting wire harnesses will be located.
3. Locate an accessory power source (+12VDC present when the ignition key is in the accessory or
run positions. 0VDC should be present when the ignition key is in the OFF position), and a good
ground location. Generally, these wires can be located at the ignition switch or fuse box.
NOTE: Ensure that the fuse on the wire harness remains intact during the installation and is
connected directly to the accessory power source. Removal of the fuse may result in
vehicle wiring damage.
4. Run the wire harnesses throughout the vehicle as required. (Examples of suggested wiring
configurations are detailed on the following pages.)
5. Be sure that all wiring is protected from sharp edges and is routed in such a manner that it will
not be pinched when fully installed.
6. Be sure to leave enough slack in the wiring at each component to allow for sufficient working
room.
- 8 -