Audiovox FLO TV Installation Manual page 24

To connect FLO TV to a Factory VES via Hardwired Integration:
If mating connectors are available for the connectors between the Factory VES and the Factory A/V
Input, as indicated in Figure 2, the FLO TV A/V Input and Output can be connected there. This allows
the end user to maintain the use of the Factory A/V Input.
1. Locate the connectors between the Factory VES and the Factory A/V Input and verify if
mating connectors are available.
2. Connect the RCA Male to Male Harness to the FLO TV A/V Output connectors on the Main
Harness. Route the RCA Male to Male Harness to the Factory VES mating connector location.
3. Connect the RCA Male to Male Harness to the Factory VES mating connector as required.
4. Connect the FLO TV A/V Input to the Factory A/V Input mating connector as required.
To connect FLO TV to an aftermarket installed VES:
The Audio/Video Output connectors on the Main Harness provide the audio and video output from the
FLO TV Module, which must be connected to the vehicle's aftermarket VES. Refer to Figure 3, herein,
for an overview of the wiring diagram.
1. Locate the aftermarket VES Audio/Video Input jacks.
2. Connect one end of the RCA Male to Male Harness to the Audio and Video Outputs on the
FLO TV Module Main Harness.
- 24 -