Audiovox FLO TV Installation Manual page 16

6. Clean the surface area of the vehicle where the FLO TV Antenna and antenna tail will be
installed. Ensure that the vehicle surface is clean and clear of any dirt or debris.
7. Remove the plastic liner from the adhesive backing on the bottom of the FLO TV Antenna.
Remove the two plastic liners from the adhesive backings on the antenna tail.
8. Place the FLO TV Antenna and antenna tail on the vehicle roof. The double sided tape and
magnet will secure the antenna and antenna tail in the desired location. (See Figure 6, FLO TV
Antenna Final Installation)
9. Verify that the installation location of the FLO TV Antenna and antenna tail are correct. Firmly
press the FLO TV Antenna and antenna tail down for approximately one minute to ensure
complete tape adhesion. Allow a 72 hour period for the adhesive tape to cure completely, avoid
car washes during this period.
Figure 6 – FLO TV Antenna Final Installation
- 16 -