Audiovox FLO TV Installation Manual page 17

Routing the Antenna Cable
When the antenna has been mounted on the vehicle, the antenna harness can be routed to the FLO TV
Module.
1. Route the antenna cable from the antenna mounting position to the interior of the vehicle,
working the cable under the rear window molding. (See Figure 7, Routing the Antenna Cable)
2. At the lowest point of the rear window, route the cable into the trunk, taking advantage of the
existing cable conduits. Route the antenna harness from the trunk to the passenger
compartment and then to the FLO TV Module Antenna connector.
3. In SUV's, Minivans, etc., route the cable into the vehicle under the rubber molding of the hatch
door or rear tailgate, and then under the interior trim.
4. Avoid exposing the cable in the driver and passenger areas where it could become entangled in
feet or other objects.
5. Plug the antenna cable plug into the FLO TV Antenna connector on the FLO TV Module. The
antenna plug will snap onto the connector when it is fully seated on the antenna connector.
NOTE: The exact routing of the antenna cable may vary depending upon where the FLO TV Module will
be installed. Avoid interfering with side curtain airbag locations on the front and back pillars
and above doors.
- 17 -