Table of Contents
Advertisement
Input Power Connection
The main harness for the FLO TV Module contains a filter box for the 12V ACC line connection. The
main harness also has an in-line fuse for the ACC connection.
1.
Connect the ACC input wire to an ignition switch input power line or a switched accessory
power line. The ACC input wire is indicated by the harness jacket color red and the "ACC"
flag on the wire.
2.
Connect the Ground input wire to a vehicle ground line. The Ground input wire is indicated
by the harness jacket color black and the "GND" flag on the wire.
3.
Ensure that the ACC line is not connected to battery power as this will drain the vehicle
battery. Test the ACC line to validate that the line goes to 0 volts when the vehicle is shut
off.
4.
Route the input power leads to the FLO TV Module installation location.
5.
Connect the 14 pin Main Harness Connector to the 14 pin connector on the FLO TV Module.
- 21 -
Advertisement
Table of Contents
Troubleshooting
