Audiovox FLO TV Installation Manual page 19

Wired Remote Control Installation
The wired remote control should be installed in the front seating area of the vehicle, where it can be
easily accessed, but not positioned where it could distract the driver or obstruct the driver's view. It
should also not be located where the wired remote control or its harness could interfere with the
operation of the airbags in the vehicle. It is recommended that the wired remote control is installed in
the vehicle's center console or glove box and the attached antenna installed on the windshield, two
inches below the top edge of the glass. The antenna should not obstruct the driver's view (see figure
8)
The wired remote control is intended for use in the event that the wireless remote control is lost or if
the batteries are dead. The wired remote can also be used to change channels from the front
passenger compartment for front seat listening of FLO TV content.
1. With the desired installation location of the wired remote control chosen, route the wire harness
to the FLO TV Module installation location.
2. Route the antenna to the windshield, following the A pillar and tucking the wire into the
headliner. Locate the antenna 2 inches below the top of the windshield (see figure 8), remove
the adhesive backing and press the antenna to the windshield.
3. Connect the 8 pin connector on the remote control to the 8 pin connector on the FLO TV
Module.
- 19 -