Advertisement
Quick Links
Advertisement
Related Manuals for Audiovox Automobile Accessories
Summary of Contents for Audiovox Automobile Accessories
- Page 2 Remove door panel. ~,;~,"I,i::-' sure the centering adhesive is firmly applied to the panel...
-
Page 3: Regulator Assembly
MANUALL y CHECK MOVEMENT Adjust the registers or guides If the window does not operate freely OPTIONAL OPERA A .IN ORDER TO USE THE SMALLEST CAP ON SOME VEHICLES, IT MA Y BE NECESSARY TO MOVE BACK THE WINDOW B .AFTER REMOVING ORIGINAL TO CHOOSE... - Page 4 C .INSERT SPACERS BETWEEN Check that the bolts of the window assembly are tight KIT NO.3 From Kit No.3, choose the correct adaptor for the model of vehicle. See adaptor Table below. N. 1 ALFA ROMEO -AUTOBIANCHI OATSUN -FIAT -LANCIA -MERCEOES OPEL-PORSCHE-SUBARU N.
- Page 5 Take caution in removing adaptor from Kit. Do not twist-off. If the handle is fixed with a screw, INSERT GEAR INTO TRANSMISSION KIT NO.4 Geared sleeve to be inserted towards inside of vehicle A) Insertion from the red marked side. B) Insertion from the opposite Cear Conversion A) Wrong: too long.
- Page 7 A) Remove the screws. B) Rotate the geared motor to the required C) Retighten the screws in their seats. Drill door panel to hook-up springs, IMPORTANT: The power cable for the motor must always be positioned K'T,1!9"1. ~ , , ., , ./ .(~l .('(I...
- Page 8 Take springs and wire clip out of KIT No 1) Spring. 2) Wire clip. Hook up springs and lock hooks IN CASE THE MOTOR, OR PARTS OF IT, ARE IN DIRECT CONTACT WITH ANY METAL PARTS, THE SUPPLIED PADDING SHOULD BE USED AS SHOWN BELOW.
- Page 11 Small. No.1 Medium No.2 No.3 Larg. grommet retainer ring KIT NO.1 --.:- :"1 , '""U --' grommet has to come through with retainer ring. To choose the proper grommet -Insert grommet cap no.1 no.2 (MEDIUM) and then, if necessary, A) No.1 SMALL (wrong: too short).
- Page 12 UNIVERSAL ELECTRIC WITHOUT CLUTCH ART. 33000013 [!!J DOOR Fit the Cap on the grommet NOTE! When the regulator pivot does not come out from the panel (photo A and B) you can use cap No. O for a better appearance. WINDOWS PANEL and fit the panel on the door...
-
Page 13: Installation
INSTALLATION EXAMPLE BUICK CENTURY (4 Doors) front -insert gear H 15 (insert from red marked -adaptor No.8 -turn transmission side of geared motor towards -affix geared motor with springs -grommet No.1 -cap No.1 CHEVROLET FULL SIZE mod. -insert gear H 15 (insert from red marked -adaptor No.8 -turn... - Page 14 FORD TEMPO front right -adjust bracket on transmission -rotate geared motor 1800 on transmission -insert gear H 15 (insert from red marked -adaptor No.12 -apply paddings to geared motor -turn transmission side of geared motor towards inside of car -affix geared motor with bracket shortened...
- Page 16 CHEVROLET/GMC S-10/15 PICKUP -shorten bracket on transmission 1.6" -gear H 15 (insert from red marked side) -adaptor No.8 -apply paddings to geared motor -turn transmission side of geared motor towards inside of car -affix geared motor with two brackets -grommet No.1 (may need to use with 2.9"...
-
Page 18: Electrical Circuit
Listed here are wiring diagrams of typical installations for the Electric window kits using the wiring kits. NOTE! For safety reasons it is necessary that the power supply to the windows nected to the appropriate It is recommended that only wiring ble, proper wiring of at least 16 AWG must be used with the suitable in-Iine fuse. - Page 19 ELECTRICAL CIRCUIT: 3 SWITCH * Use original wiring, WITH 6 CONTACTS Art. 33020010 complete with 25 Amp. SEPARATE LIGHT fuse.
- Page 20 FUSE 50 Amp...