Remote Menu - Sony PVM-741 Operating Instructions Manual

Submenu
SDI AUDIO SETTING

REMOTE menu

REMOTE
PA R A L L E L R E M O T E :
S E R I A L R E M O T E :
M O N I T O R :
C O N T R O L L E R :
C O N N E C T I O N :
PARALLEL REMOTE
REMOTE – PA R A L L E L R E M O T E
PA R A L L E L R E M O T E :
1 P I N :
2 P I N :
3 P I N :
4 P I N :
6 P I N :
7 P I N :
8 P I N :
F O R C E D TA L LY:
30
Adjustment Using the Menus
Setting
Sets the audio channel when SDI
signal is input.
• 3G/HD/SD: Selects from among
channels CH1 to CH16, odd
channel + even channel
(CH1+CH2,
CH3+CH4···CH15+CH16)
and OFF.
You can display the L/R audio
levels of the selected channels. (see
"WFM/ALM/VECTOR (waveform
monitor, audio level meter, and
vectorscope) SETTING" on page
25).
• SPEAKER OUTPUT: Select an
audio format to output from
speakers, headphone jack,
and AUDIO OUT
connector.
EMBEDDED: Outputs an
audio signal embedded in
SDI.
ANALOG: Outputs an
audio signal that comes from
the AUDIO IN connector.
Note
The SDI audio signal is compatible
only with 24 bit.
xxxxxxx
xxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxx
Submenu Setting
PARALLEL REMOTE Selects the PARALLEL REMOTE
connector pins for which you want
to change the function.
You can assign various functions to
1 to 4 pins and 6 to 8 pins. The
following lists the functions you
can assign to the pins.
• – – – ("– – –": No function is
• COMPOSITE
• HDMI
• SDI 1
• SDI 2
• WFM/ALM/VS
• OVERSCAN
• NORMAL
• NATIVE
• 4:3
• 16:9
• TALLY R
• TALLY G
• BLUE ONLY
• MONO
• H/V DELAY
• 16:9 MARKER
• 15:9 MARKER
• 14:9 MARKER
• 13:9 MARKER
• 1.85:1 MARKER
• 2.35:1 MARKER
• 1.85:1 & 4:3 MARKER
• 4:3 MARKER
• CENTER MARKER
• MARKER MAT HALF
• SAFE AREA 80%
• SAFE AREA 85%
• SAFE AREA 88%
• SAFE AREA 90%
• SAFE AREA 93%
• FLIP H
• FLIP V
• FLIP HV
Notes
• If you use the PARALLEL
REMOTE function, you need to
connect cables. For more details,
see page 33.
• Set MARKER ENABLE
(page 24) to ON to control the
aspect marker and center
marker.
assigned.)