Sony PVM-741 Operating Instructions Manual page 26

Submenu Setting
When VECTOR is selected
Red
Bar I
Yellow
Bar Q
Black
Green
Color target frame
Channel number
(The channel number which is selected in
SDI AUDIO SETTING is displayed.)
POSITION Sets the position of the WFM/ALM/
VECTOR display. You can select from
among 1 to 4.
• 1: Bottom left
• 2: Bottom right
• 3: Top right
• 4: Top left
COLOR Selects the displayed line color from
white (W), red (R), green (G), blue (B)
and yellow (YL), when WFM is
selected.
INTENSITY Sets the brightness of the waveform, etc.
The larger the value, the brighter the
waveform.
ZOOM When ON is set, 0-20 IRE areas will be
zoomed when WFM is selected, or black
areas will be zoomed when VECTOR is
selected.
LINE SELECT Select ON to display the wave form of
the line assigned in LINE POSITION
below, when WFM is selected.
LINE POSITION Sets the line position when WFM is
selected.
When the numerical value is increased,
the line will move down; when
decreased, the line will move up.
TARGET Select 75 or 100. Switches the
vectorscope target between 75% and
100%.
26
Adjustment Using the Menus
Audio level
Magenta
(dB)
OVER
0
-10
-20
-30
-60
1 2
Cyan Blue
FOCUS SETTING
USER CONFIG – FOCUS SETTING
F O C U S M O D E :
C O L O R :
F R E Q U E N C Y:
R A N G E :
G A I N :
Submenu Setting
FOCUS MODE Switches the focus mode.
• STD: An image with sharpened edges
is displayed.
• COLOR: Displays the intensified
areas of images with color
selected in COLOR below.
• OFF: FOCUS MODE is deactivated.
COLOR Selects the displayed intensified color
from white (W), red (R), green (G), blue
(B), and yellow (YL).
FREQUENCY Sets the center frequency of the edge
sharpening signal.
You can select from L, M, MH, H.
RANGE Sets the amount by which the level of
edge sharpening may vary.
You can set from 1 to 3.
GAIN Sets the level of edge sharpening.
You can select from 0 to 100.
FUNCTION BUTTON SETTING
USER CONFIG – FUNCTION BUTTON SETTING
F 1 B U T T O N :
F 2 B U T T O N :
F 3 B U T T O N :
F 4 B U T T O N :
F 5 B U T T O N :
F 6 B U T T O N :
F 7 B U T T O N :
Submenu Setting
F1 BUTTON to F7 Assigns the function to the function
BUTTON buttons of the front panel and turns the
function on or off.
You can assign the function from among
SCAN, ASPECT, BLUE ONLY,
MONO, MARKER, I/P MODE, etc.
Factory setting
• F1 button: BRIGHTNESS
• F2 button: CONTRAST
• F3 button: CHROMA
• F4 button: SCAN
• F5 button: H/V DELAY
• F6 button: VOLUME
• F7 button: I/P MODE
xxx
xx
x
x
x
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx
xxxx