Sony PVM-741 Operating Instructions Manual page 10

You can assign various functions in FUNCTION
BUTTON SETTING of the USER CONFIG menu.
Press the button BRIGHTNESS, CONTRAST,
CHROMA, VOLUME, PHASE, or APERTURE
function assigned to display the adjustment screen.
Press the same button again, and the adjustment screen
disappears, but you can adjust the value without the
setting value display.
For details of the function assigned to the function
button, see page 27.
h Menu operation buttons
Displays or sets the on-screen menu.
Menu selection control
When the menu is displayed, turn the control to select
a menu item or setting value, and then press the
control to confirm the setting.
If the menu is not displayed and the menu selection
control is pressed, the characters that represent the
names of the buttons light up. Also, the names of the
function selected in FUNCTION BUTTON
SETTING of the USER CONFIG menu appear on the
screen.
Alternatively, if the menu is not displayed and the
menu selection control is pressed for more than two
seconds, the signal format is displayed on the screen.
RETURN button
When the menu is displayed, press the button to reset
the value of an item to the previous value (except
some items).
When the menu is not displayed, press the button to
display the name of the function selected in
FUNCTION BUTTON SETTING of the USER
CONFIG menu.
MENU button
Press to display the on-screen menu.
Press again to clear the menu.
i 1 (standby) switch and indicator
Press to turn on the power when this unit is in standby
mode. The indicator lights in green. Press the switch
again to set the monitor in standby mode. The indicator
goes out. If a temperature increase occurs inside the unit
when using the unit in a high temperature environment,
in SILENT MODE, or when a fan error occurs, the
indicator flashes in green and amber alternately. In
power saving mode, it lights in amber.
10
Location and Function of Parts and Controls
Using the stand
Pull the stand toward you to tilt the monitor screen by
15°.
The mounting position of the stand can be changed.
Move the mounting screws on the underside of the stand
to positions A and C, or positions B and C.
A C B
A C B
A and C: Sets the stand towards the back.
B and C: Sets the stand towards the front.
When using the optional VF-510 Monitor ENG Kit, set
the stand at positions B and C.