Choosing A Place For The Printer - Star TSP100LAN Hardware Manual

1-2. Choosing a place for the printer

Before actually unpacking the printer, you should take a few minutes to think about
where you plan to use it. Remember the following points when doing this.
 Choose a firm, level surface where the printer will not be exposed to vibration.
 The power outlet you plan to connect to for power should be nearby and unobstructed.
 Make sure that the printer is close enough to your host computer for you to connect
the two.
 Make sure that the printer is not exposed to direct sunlight.
 Make sure that the printer is well away from heaters and other sources of extreme
heat.
 Make sure that the surrounding area is clean, dry, and free of dust.
 Make sure that the printer is connected to a reliable power outlet. It should not be on
the same electric circuit as copiers, refrigerators, or other appliances that cause power
spikes.
 Make sure that the room where you are using the printer is not too humid.
 This device employs a DC motor and switches that have an electrical contact point.
Avoid using the device in environments where silicon gas can become volatile.
WARNING
 Shut down your equipment immediately if it produces smoke, a strange odor, or un-
usual noise. Immediately unplug the equipment and contact your dealer for advice.
 Never attempt to repair this product yourself. Improper repair work can be dangerous.
 Never disassemble or modify this product. Tampering with this product may result
in injury, fire, or electric shock.
– 2 –