Planning; Position Of Suspension - Schwank infraSchwank D 15U Technical Manual

Radiant tube heater with single-, two-stage or modulating operation
Hide thumbs Also See for infraSchwank D 15U:
Table of Contents

Advertisement

infraSchwank D / calorSchwank D - shape U

4 Planning

Room temperature control
Radiant tube heating-systems must be equipped with
a temperature control.
Section heating is allowed without temperature control.

Position of suspension

Suspension height
Radiant tubes must be positioned so that no one in
the radiation area is exposed to an extreme high heat
level. This is ensured when the minimum suspension
heights shown in the following table are adhered to:
Nominal
Suspension height in m
thermal load in
(max. radiation 200 W/m
MJ/h (type)
A = horizontal
60 (15U)
3.5m
75.9 (20U)
4.0m
115.9 (30U)
4.8m
155.8 (40U)
5.5m
Tab 1:
Minimum suspension heights
Key:
A = Minimum height when hanging horizontally
B = Minimum height when hanging angled
b
a
Type
[cm]
[cm]
infra
15 U
110
20
20 U
110
20
30 U
130
20
40 U
170
25
Tab 2:
Safe distances
Key:
a = Minimum radial safety distance (inside radiation area)
b = Minimum upper safety distance when hanging horizontally
c = Minimum upper safety distance when hanging angled
d = Minimum lateral distance to supply pipes outside radiation area
Distances to flammable materials in the
radiant area
Radiant tubes must be positioned so that the surface
temperature of
 components with flammable materials,
 flammable equipment, stored flammable materials
not exceed 65°C above ambient.
6
2
)
B = angled (30°)
3.1m
3.6m
4.3m
4.9m
d
c
[cm]
[cm]
calor
infra
calor
10
50
15
15
10
50
15
15
10
50
15
15
10
50
25
15
Do not place articles on or against
this appliance.
Do not use or store flammable
materials near this appliance.
Do not spray aerosols in the
vicinity of this appliance while it is
in operation.
Fig 3: Suspension heights and distances for horizontal
application
Fig 4:
Suspension heights and distances for angled
application
Direction of radiation
Radiant tubes infraSchwank D / calorSchwank D can
be positioned horizontal or at an angle (max. 30° from
vertical). For this purpose suspension steel chains
and cables are installed at the suspension brackets.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents