Reflector Elongation; Set Angled Mounting Tubes - Schwank infraSchwank D 15U Technical Manual

Reflector elongation

Vertical elongation of reflectors b=415mm for thermal
protection. The numbers reflector elongation (single
sheets) is depend on required protection (one side
both side, protection length) and the power of the
radiant heater.
Delivery scope
Reflector elongation consist of
 numbers of sheet reflector elongation
 mounting material
Assembling
1. Assembling and mounting tubes with reflectors
complete acc. manual (see chapter 9, page 16-19).
2. Fix screws with distance sleeve and mounting
angles A at hangers as required.
3. Mount end bracket B at turn around box.
4. Put reflector elongation sheet B on mounting
angle A. Screw both parts together with the
added clip C and screw/nut M8 and lock a nut to
ensure the reflector elongation sheets.
5. Fix reflector elongation sheets to another with
screw/nut M8.

At heaters with axial reflector elongation
the last suspension bracket on the
burner side must be mounted at the
junction point reflector/reflector end
plate.
A
B
C
Fig 35, 36: Assembling order reflector elongation
infraSchwank D / calorSchwank D - shape U
D
C

Set angled mounting tubes

Bracket to ensure form and position of reflectors
when the heater is mounted angled (>15°). Bracket to
mount at each junction point reflector/reflector, not at
reflector end caps.
Delivery scope
Mounting set consist of
 numbers of brackets
 mounting material
Assembling
1. Assembling and mounting of tubes complete
(without reflectors) acc. manual
(see chapter 9, page 16-19).
2. Lay first reflector on turn around box and first
hanger, fix it at turn around box with two screws.
3. Fix angled bracket D with screws and nuts M8 at
first hanger, bracket under reflector.
4. Put on next reflector, reflectors are fixed to
another by 3 screws/nuts M5, middle screw
through angled bracket.
5. Further assembling as usually acc. to manual.
D
Fig 37, 38: Assembling order set angled mounting
33