Xir3 Log Placement - Napoleon XIR3N Installation And Operating Instructions Manual

14
4.4

XIR3 LOG PLACEMENT

A. Place the rear log into position
lining up the holes in the bottom
with the studs located at the rear of
the firebox. Ensure it is tight to the
burner.
D. Place the left front log into
position, lining up the 2 holes in the
bottom with the studs located on
the left side of the burner.
G. Position the right charcoal strip
in front of the right front log, lining
up the 2 holes in the bottom with
the 2 front right studs.
W415-1033 / A / 10.12.11
PIN
LOG SUPPORT
B. Place the left middle log behind
the left log support. Insert a pin
(supplied) into the right end of the
log.
E. Place the right front log into
position, lining up the 2 holes in the
bottom with the studs located on
the right side of the burner.
H. Position a pin into the left side
hole of the left middle log, move
the left crossover log into position,
lining up the top hole with the pin.
C. Insert the right middle log end
onto the left log pin and place it
behind the right support. Adjust the
log supports tight to these logs to
hold them in an upright position and
ensure they are tight to the burner.
F. Position the left charcoal strip in
front of the left front log, lining up
the 2 holes in the bottom with the 2
front left studs.
I. Position a pin into the right side
hole of the right middle log, move
the right crossover log into position,
lining up the top hole with the pin.