On/Off Switch Installation (Ir3 Only); Battery Installation (Xir3 Only); Battery Installation (Ir3 Only) - Napoleon XIR3N Installation And Operating Instructions Manual

16
4.8

ON/OFF SWITCH INSTALLATION (IR3 ONLY)

Snap the ON/OFF switch into the slot located in the top right side of the surround. Run the two black wires
up the side of the surround, through the wire clips and connect to the switch terminals (see surround leaflet
instructions for details).
4.9

BATTERY INSTALLATION (XIR3 ONLY)

4 AA batteries must be installed into the receiver before operation is
possible in the XIR3. The receiver is located in the bottom left corner of
the appliance.
If receiver removal is necessary, remove the left access panel from the front
of the appliance. Remove the 2 screws holding the receiver in place. Pull
the receiver through the access hole and replace.

4.10 BATTERY INSTALLATION (IR3 ONLY)

4 AA batteries must be installed in to the DC battery pack before operation is possible in the IR3. The battery
pack is located in the bottom right corner of the appliance.
W415-1033 / A / 10.12.11
WIRE CLIPS
RECEIVER
RECEIVER PLATE
SCREWS