Table of Contents
Advertisement
20
6.2
XIR3 OPERATION
IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
6.2.1
GENERAL TRANSMITTER LAYOUT
TRANSMISSION
THERMOSTAT
CHILD SAFETY
OFF/ON/SMART
LOCK OUT
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME
FAN
6.2.2
APPLIANCE OPERATION
A.
Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required
as back up to household electricity).
B.
Place the 3 position slider switch of the receiver in the "Remote" position.
C.
Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole
marked "PRG" on the receiver front cover. The receiver will "beep" three (3) times to indicate that it is
ready to synchronize with the transmitter.
D.
Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter.
With the batteries already installed in the transmitter, push the "ON" button. The receiver will "beep"
four times to indicate the transmitter's command is accepted and set to the particular code of that
transmitter. The system is now initialized.
W415-1033 / A / 10.12.11
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
THE GLASS DOOR OPENED OR REMOVED.
ROOM
LOW BATTERY
ALARM
TEMPERATURE
AUX. OUTPUT
SPLIT VALVE
35.18
WARNING
!
35.2A
Hide quick links:
Advertisement
Table of Contents
