Log Placement - Napoleon GX36NTREA-1 Manual

more uniform as colour pigments burn in during the heat-activated curing process."
Insert only if
8.6

log placement

applicable ---->
WARNING
!
Log Number
• Failure to position the logs in accordance with these diagrams or failure to use only logs specifi cally approved
1
with this appliance may result in property damage or personal injury.
• Logs must be placed in their exact location in the appliance. Do not modify the proper log positions, since
2
appliance may not function properly and delayed ignition may occur.
3
• The logs are fragile and should be handled with care.
4
5
PHAZER™ logs and glowing embers, exclusive to Napoleon, provide a unique and realistic glowing effect that
"PHAZER™ logs [and glowing embers], exclusive to Napoleon/Continental, provide a unique and realistic
is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing ef-
6
glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a
fect. Log colours may vary. During the initial use of the appliance, the colours will become more uniform as colour
maximum glowing effect. Log colours may vary. During the initial use of the appliance, the colours will become
7
pigments burn in during the heat-activated curing process. Blocked burner ports can cause an incorrect flame
more uniform as colour pigments burn in during the heat-activated curing process."
pattern.
8
9
Insert only if
applicable ---->
10
Log Number
1
2
3
4
5
6
Stud (Log #1)
7
8
9
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
10
Stud (Log #2)
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
Stud (Log #3)
IF APPLICABLE, INSERT DRAWING OF BURNER/SUPPORT WITH APPROPRIATE LA-
IF NOT APPLICABLE, HIDE THIS SECTION AND USE BOXES BELOW.
A1
note:
Log numbers are located on the bottom or back of the logs.
Part Number
If applicable, insert the following statement:
note:
Log numbers are located on the bottom or back of the logs.
Part Number
Burner Ports
A1
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
B1
C1
BELS (I.E. STUDS, PILOT SHIELD, BURNER PORTS, ETC.).
Burner Overview
Notch
1
A2
Description
Description
Pilot Shield
A2
B2
D1
Studs (Log #4)
A2
finishing
Stud (Log #1)
Stud (Log #2)
D2
1
W415-3097 / 07.06.21
2
EN
51