Installing The Ink Cartridges; Filling With Ink For The First Time - Roland VersaCamm SP-540i Setup Manual

5. Installing the Ink Cartridges

Filling with Ink for the First Time

Special procedures are required when installing ink cartridges for the first time. These are required only once, when installing
ink cartridges for the first time after shipment from the factory.
You first clean the print heads using cleaning fluid, then fill with the inks of the various colors.
This operation requires two SOL INK cleaning cartridges and two dummy cartridges.
Never under any circumstances use anything other than the specified type of ink or cleaning fluid.
Installing the Ink Cartridges
Be sure to follow the on-screen inst-
ructions for insertion and removal.
Keep the labeled side face up.

Insert and remove slowly, one at a time.

Insert firmly, as far as it will go.

Insert firmly until you hear a beep.

During cleaning, you insert and remove cartridges several times. The on-screen messages indicate which to insert and remove,
and when to insert and remove them.
Insert each color ink cartridge into the slot labeled with the matching color. The SOL INK cleaning cartridges are not dif-
ferentiated by color.
CAUTION
28
Never insert your hand or fingers into the opening of the front cover.
The print heads move at high speed inside the cover. Contact may cause injury.
Slot number