6. Installing the Blade
3.
Install the blade holder.
Loosen the screw shown in the figure.
Support the screw from below and insert the blade holder.
Insert until the
collar is flush with
the surface.
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
Important Note on the Handling and Use of the Cutting Carriage
Leave the cutting-carriage screw loose when no blade holder is installed. Keeping the screw tightened causes the blade-
holder insertion hole to become gradually smaller, making installation difficult.
34
Screw
Screw
Support it from below.
Close the front cover, then press
.