Setting Automatic Rinsing; Setting The Steam System - Miele CVA 5060 Operating And Installation Instructions

Settings: customising your machine

Setting Automatic rinsing

To remove any coffee grounds and
residual milk from the system, the water
piping must be rinsed through before
the first drink of the day is prepared. If
Automatic rinsing is selected, the rinse
cycle will take place automatically
whilst the machine is still cold when the
machine is switched on. This will also
pre-heat the system because hot water
is used for the rinse process. A
message will appear in the display to
let you know what is happening. The
machine will also run an automatic rinse
before it switches off, if it has been
used to prepare a drink.
The machine is delivered with the
Automatic rinsing option set to "On".
To prevent water from
running into the drip tray,
always place an empty cup
or the small cleaning container under
the central spout before making the first
drink.
^ Select "Settings F" from the main
menu and touch the OK sensor.
Settings
Automatic rinsing
Steam system
^ Touch the right arrow sensor until
"Automatic rinsing" is highlighted and
touch the OK sensor.
^ Touch one of the arrow sensors to
select "On" or "Off" and touch the OK
sensor.
It is a good idea to set this
option to "On" so that the
rinse process cannot be
forgotten.
32

Setting the Steam system

The machine has two heating systems.
The Steam system enables milk froth or
hot milk, and coffee or espresso to be
made at the same time. To save
energy, the Steam system can be
switched off if steam is not required all
the time.
If this option is switched off, milk
froth and hot milk can still be made;
however the machine must be
heated up first.
The Steam heating system remains
active as long as the machine is still
on.
^ Select "Settings F" from the main
menu and touch the OK sensor.
Settings
Steam system
Lighting
^ Touch the right arrow sensor until
"Steam system" is highlighted, and
then touch the OK sensor.
^ Touch one of the arrow sensors to
select "On" or "Off", and then touch
the OK sensor.